浏览全部资源
扫码关注微信
两相CO2喷射器混合室长度和扩压室角度影响研究
Effects of Mixer Length and Diffuser Angle on Two-Phase CO2 Ejector
- 制冷学报 2025年46卷第1期 页码：132-139
- 作者机构：
1.上海交通大学制冷与低温工程研究所 上海 200240
2.南京航空航天大学能源与动力学院 南京 210016
3.上海市高效冷却系统工程技术研究中心 上海 200240
- 作者简介：
陈江平，男，博士，教授，上海交通大学制冷与低温工程研究所，021-34206775，E-mail：jpchen_sjtu@163.com。研究方向：制冷与低温工程、车用空调技术。
- 基金信息：国家自然科学基金(51776119)
DOI：10.12465/j.issn.0253-4339.2025.01.132
中图分类号： TB61+1;TB657.5收稿日期：2023-11-22，
修回日期：2023-12-10，
录用日期：2024-01-24，
纸质出版日期：2025-02-16
- 稿件说明：
移动端阅览
龙俊安, 潘美娜, 施骏业, 等. 两相CO2喷射器混合室长度和扩压室角度影响研究[J]. 制冷学报, 2025,46(1):132-139.
Long Junan, Pan Meina, Shi Junye, et al. Effects of Mixer Length and Diffuser Angle on Two-Phase CO2 Ejector[J]. Journal of refrigeration, 2025, 46(1): 132-139.
龙俊安, 潘美娜, 施骏业, 等. 两相CO2喷射器混合室长度和扩压室角度影响研究[J]. 制冷学报, 2025,46(1):132-139. DOI： 10.12465/j.issn.0253-4339.2025.01.132.
Long Junan, Pan Meina, Shi Junye, et al. Effects of Mixer Length and Diffuser Angle on Two-Phase CO2 Ejector[J]. Journal of refrigeration, 2025, 46(1): 132-139. DOI： 10.12465/j.issn.0253-4339.2025.01.132.
摘要
利用已验证的CFD模型研究不同工况下混合室长度和扩压室锥半角对喷射器升压性能的影响。结果表明：在给定工况下，存在最优的混合室长度和扩压室角度参数组合使喷射器的升压性能最高。两者对喷射器性能的影响具有强相关性：当混合室足够长时，掺混较为充分，混合流扩压时不易发生流动分离，扩压室锥半角在0.5°~3°变化对喷射器性能的影响相对较小；而混合室较短时，扩压室壁面附近容易产生湍流损失，扩压室角度的影响较大。此外，最优结构参数受到运行工况的影响，随喷嘴入口压力和温度降低，最优混合室长度增加，最优扩压室角度减小。在研究工况和喷嘴配置下，喷射器最优混合室长度约为38 mm，最优扩压室锥半角为1°~1.5°。
Abstract
This study employed a validated computational fluid dynamics (CFD) model to investigate the influences of the mixer length and diffuser angle on the ejector pressure-recovery performance. The results demonstrated that an optimal combination of mixer length and diffuser angle exists at which the ejector has the highest performance. The effects of these two geometrical parameters on the ejector performance were highly consistent. When the mixer length was sufficiently long
the mixing was sufficient
and the mixed flow was not subjected to separation during pressure recovery. Under these circumstances
the effect of the diffuser angle on the ejector performance was relatively trivial
varying between 0.5° and 3°. However
when the mixer length was short
the flow was prone to turbulent losses near the diffuser wall. In this case
the effect of the diffuser angle was significant. In addition
the optimal geometries were affected by the operating conditions. The optimal mixer length increased as the nozzle inlet pressure and temperature decreased
whereas the optimal diffuser angle decreased. Under the conditions and nozzle configuration investigated in this study
the optimal mixer length was approximately 38 mm and the optimal diffuser cone half angle was between 1° and 1.5°.
关键词
Keywords
references
俞彬彬 , 龙俊安 , 王丹东 , 等 . 电动汽车热泵全生命周期气候性能评估模型与环保制冷剂减排分析 [J ] . 科学通报 , 2023 , 68 ( 7 ): 841 - 852 .
( YU Binbin , LONG Jun'an , WANG Dandong , et al . Life cycle climate performance (LCCP) evaluation model for electric vehicle heat pumps and emission reduction analysis of low-GWP refrigerants [J ] . Chinese Science Bulletin , 2023 , 68 ( 7 ): 841 - 852 .)
YU Binbin , YANG Jingye , WANG Dandong , et al . An updated review of recent advances on modified technologies in transcritical CO 2 refrigeration cycle [J ] . Energy , 2019 , 189 : 116147 .
NAKAGAWA M , MARASIGAN A R , MATSUKAWA T , et al . Experimental investigation on the effect of mixing length on the performance of two-phase ejector for CO 2 refrigeration cycle with and without heat exchanger [J ] . International Journal of Refrigeration , 2011 , 34 ( 7 ): 1604 - 1613 .
HAIDA M , SMOLKA J , PALACZ M , et al . Numerical investigation of an R744 liquid ejector for supermarket refrigeration systems [J ] . Thermal Science , 2016 , 20 ( 4 ): 1259 - 1269 .
YOICHIRO K , GOTA O , SHAN Zhiwei . Ejector energy-saving technology for mobile air conditioning systems [J ] . SAE International Journal of Passenger Cars - Mechanical Systems , 2017 , 10 ( 1 ): 102 - 110 .
NIIMI T , NAKAGAWA M . Experimental research on the two-phase flow nozzle performance of the ejector for carbon dioxide [C ] // 9th International Conference on Heat Transfer, Fluid Mechanics and Thermodynamics . Malta : HEFAT , 2012 .
LI Yafei , DENG Jianqiang , MA Li . Experimental study on the primary flow expansion characteristics in transcritical CO 2 two-phase ejectors with different primary nozzle diverging angles [J ] . Energy , 2019 , 186 : 115839 .
张西平 , 邓建强 , 李亚飞 , 等 . 不同喷嘴距的CO 2 两相引射器实验研究 [J ] . 制冷学报 , 2021 , 42 ( 4 ): 20 - 27 .
( ZHANG Xiping , DENG Jianqiang , LI Yafei , et al . Experimental investigation on the CO 2 two-phase ejector with different nozzle e xit positions [J ] . Journal of Refrigeration , 2021 , 42 ( 4 ): 20 - 27 .)
NAKAGAWA M , MARASIGAN A R , MATSUKAWA T . Experimental analysis of two-phase ejector system with varying mixing cross-sectional area using natural refrigerant CO 2 [J ] . International Journal of Air-Conditioning and Refrigeration , 2010 , 18 ( 4 ): 297 - 307 .
龙俊安 , 宋霞 , 施骏业 , 等 . 两相CO 2 喷射器混合室直径优化与模拟分析 [J ] . 制冷学报 , 2023 , 44 ( 1 ): 122 - 128 .
( LONG Jun'an , SONG Xia , SHI Junye , et al . Optimization and analysis of mixer diameter of two-phase CO 2 ejectors [J ] . Journal of Refrigeration , 2023 , 44 ( 1 ): 122 - 128 .)
ELBEL S , HRNJAK P . Experimental validation of a prototype ejector designed to reduce throttling losses encountered in transcritical R744 system operation [J ] . International Journal of Refrigeration , 2008 , 31 ( 3 ): 411 - 422 .
LI Yafei , DENG Jianqiang . Numerical investigation on the performance of transcritical CO 2 two-phase ejector with a novel non-equilibrium CFD model [J ] . Energy , 2022 , 238 : 121995 .
LI Yafei , DENG Jianqiang , HE Yang . Numerical study on the interaction of geometric parameter s of a transcritical CO 2 two-phase ejector using response surface methodology and genetic algorithm [J ] . Applied Thermal Engineering , 2022 , 214 : 118799 .
LIU Guangdi , ZHAO Hongxia , DENG Jianqiang , et al . Performance improvement of CO 2 two-phase ejector by combining CFD modeling, artificial neural network and genetic algorithm [J ] . International Journal of Refrigeration , 2023 , 154 : 151 - 167 .
YAZDANI M , ALAHYARI A A , RADCLIFF T D . Numerical modeling of two-phase supersonic ejectors for work-recovery applications [J ] . International Journal of Heat and Mass Transfer , 2012 , 55 ( 21/22 ): 5744 - 5753 .
SINGHAL ASHOK K , ATHAVALE MAHESH M , LI Huiying , et al . Mathematical basis and validation of the full cavitation model [J ] . Journal of Fluids Engineering , 2002 , 124 ( 3 ): 617 - 624 .
CAREY V P . Liquid-vapor phase-change phenomena: an introduction to the thermophysics of vaporization and condensation processes in heat transfer equipment [M ] . 3rd ed . Boca Raton : CRC Press , 2020 .
MAJCHRZYK M , DZIUROWICZ D , HAIDA M , et al . Detailed numerical investigation of the CO 2 two-phase ejector 3-D CFD model based on the flow visualisation experiments [J ] . Chemical Engineering and Processing - Process Intensification , 2022 , 182 ( 1 ): 109195 .
李浩 , 张振宇 , 宋霞 , 等 . 带喷射器的跨临界CO 2 车用空调系统实验研究 [J ] . 上海交通大学学报 , 2021 , 55 ( 2 ): 179 - 187 .
( LI Hao , ZHANG Zhenyu , SONG Xia , et al . Experimental study of a transcritical CO 2 mobile air conditioning system with an ejector [J ] . Journal of Shanghai Jiao Tong University , 2021 , 55 ( 2 ): 179 - 187 .)
BANASIAK K , PALACZ M , HAFNER A , et al . A CFD-based investigation of the energy performance of two-phase R744 ejectors to recover the expansion work in refrigeration systems: an irreversibility analysis [J ] . International Journal of Refrigeration , 2014 , 40 : 328 - 337 .
0
浏览量
38
下载量
0
CSCD
- 网络PDF下载
- Meta-XML下载
- BibTeX下载
- Endnote下载
- RefMan 下载
- NoteExpress下载
- NoteFirst下载
关联资源
相关文章
相关作者
相关机构
- 地址：北京市海淀区阜成路67号银都大厦10层 邮编：100142
- 联系电话：010-68711412 Email：editor@car.org.cn
- 技术支持由北京北大方正电子有限公司提供 京ICP备09064830号-19
京公网安备11010802024621 - 本系统建议在Chrome、 IE9+ 以上版本浏览器阅读本站内容，360浏览器请切换至极速模式
- Cookies帮助我们提供服务并提供个性化体验。使用本网站，即表示您同意我们使用Cookies