引用本文
  •    [点击复制]
  •    [点击复制]
【打印本页】 【下载PDF全文】 查看/发表评论下载PDF阅读器关闭

←前一篇|后一篇→

过刊浏览    高级检索

本文已被:浏览 2701次   下载 3615 本文二维码信息
码上扫一扫!
翅片结构对翅片管换热器积灰与压降影响的实验研究
唐家俊, 詹飞龙, 胡海涛, 丁国良, 庄大伟
0
(上海交通大学制冷与低温工程研究所)
摘要:
积灰对具有不同翅片结构的翅片管换热器均会造成长效性能的衰减。本文搭建了换热器积灰可视化实验台,研究了翅片结构对积灰量及积灰后空气侧压降的影响。测试样件的翅片类型包括平直翅片、波纹翅片和开窗翅片;翅片间距范围为1.3~1.8 mm。实验结果表明:开窗翅片管换热器表面最容易沉积粉尘并增大积灰后压降,与平直翅片相比,波纹翅片和开窗翅片表面粉尘沉积量分别提高了25.6%和52.8%、积灰后压降增量分别提高了44.4%和165.6%;对于开窗翅片,小翅片间距有利于积灰并增大积灰后压降,与翅片间距1.8 mm的样件相比,翅片间距1.5 mm和1.3 mm的样件表面粉尘沉积量分别提高了26.2%和43.2%、积灰后压降增量分别提高了24.1%和49.4%;在积灰过程中,随着粉尘沉积量的增加,翅片管换热器空气侧压降先增大后保持稳定。
关键词:  翅片管换热器  粉尘沉积  压降  翅片结构  实验研究
DOI:
    
基金项目:国家自然科学基金创新研究群体科学基金(51521004)和中国博士后基金(2016M591669)资助项目。
Experimental Investigation on Influence of Fin Structures on Particle Deposition and Pressure Drop of Fin-and-tube Heat Exchangers
Tang Jiajun, Zhan Feilong, Hu Haitao, Ding Guoliang, Zhuang Dawei
(Institute of Refrigeration and Cryogenics, Shanghai Jiao Tong University)
Abstract:
The long-term performance of fin-and-tube heat exchangers with different fin structures will decay when covered with dust particles. In this paper, a visual experimental rig was established to investigate the effects of fin structures on particle deposition and air-side pressure drop. The fin types of test samples covered plain fins, wavy fins and louver fins, and the fin pitches ranged from 1.3 mm to 1.8 mm. The results show that, louver fins are most beneficial to particle deposition; the maximum particle deposition weight on wavy fins and louver fins increased by 25.6% and 52.8% respectively compared with that on plain fins, meanwhile the increment of pressure drop increased by 44.4% and 165.6% respectively. Small fin pitch can promote particle deposition and increase pressure drop; the maximum particle deposition weight on louver fins with fin pitch of 1.5 mm and 1.3 mm increased by 26.2% and 43.2% respectively compared with that on louver fin with fin pitch of 1.8 mm, meanwhile the increment of pressure drop increased by 24.1% and 49.4% respectively. The air-side pressure drop firstly increased then tended to be stable with the increase of particle deposition weight.
Key words:  fin-and-tube heat exchanger  particle deposition  pressure drop  fin structure  experimental investigation

用微信扫一扫

用微信扫一扫