引用本文:[点击复制]
[点击复制]
【打印本页】 【在线阅读全文】【下载PDF全文】 查看/发表评论下载PDF阅读器关闭

←前一篇|后一篇→

过刊浏览    高级检索

本文已被:浏览 2335次   下载 2811 本文二维码信息
码上扫一扫!
低温驱动沸石-水吸附式制冷机的性能研究
王南南,刘再冲,邓立生,何兆红,窪田光宏,大坂侑吾,黄宏宇,陈颖
0
(中国科学院广州能源研究所;中国科学院大学;中国科学院广州能源研究所;广东工业大学材料与能源学院;日本名古屋大学;日本金泽大学)
摘要:
本文研究的合成沸石-水吸附式制冷机采用FAMZ01沸石作为吸附剂,吸附床选择翅片涂抹式吸附床,通过实验考察该制冷机的制冷功率、制冷性能系数(COP)随热源温度、冷冻水进口温度的变化规律。结果表明,该吸附式制冷机在55 ℃的热源下就可以稳定输出制冷量,并在驱动热源为65 ℃左右展现其较佳的性能。
关键词:  吸附式制冷机  涂抹式吸附床  COP  热源温度
DOI:
    
基金项目:
Experimental Investigation on a Zeolite-water Adsorption Chiller Driven by Low Heat Source
Wang Nannan,Liu Zaichong,Deng Lisheng,He Zhaohong,KUBOTA Mitsuhiro,OSAKA Yugo,Huang Hongyu,Chen Ying
(Guangzhou Institute of Energy Conversion, Chinese Academy of Science;University of the Chinese Academy of Sciences;Guangzhou Institute of Energy Conversion, Chinese Academy of Science;School of Material and Energy, Guangdong University of Technology;Nagoya University;Kanazawa University)
Abstract:
A novel type of adsorption chiller with synthetic zeolite-water was proposed, in which the zeolite FAMZ01 was chosen as the adsorbent and coated adsorber with fin as adsorber. The effects of heat source temperature and chilled water inlet temperature on cooling power and coefficient of performance (COP) were obtained experimentally. The results showed that the adsorption chiller can supply the chilled water steadily at driven heat source temperature of 55℃, and is with better performance at the driving heat source temperature about 65 ℃.
Key words:  adsorption chiller, coated adsorber, coefficient of performance, heat source temperature

用微信扫一扫

用微信扫一扫