Modeling of Lubricant Retention in Suction Lines with R32/PVE Oil Mixture Based on Different Flow Patterns

Hu Jinting; Gu Bo; Zeng Weijie; Zhang Zhiting; Wu Pengzhan

doi:10.3969/j.issn.0253-4339.2023.02.104

您当前的位置：

首页 >

文章列表页 >

Modeling of Lubricant Retention in Suction Lines with R32/PVE Oil Mixture Based on Different Flow Patterns

更新时间：2024-07-18

- Modeling of Lubricant Retention in Suction Lines with R32/PVE Oil Mixture Based on Different Flow Patterns
- Journal of Refrigeration Vol. 44, Issue 2, (2023)
- 作者机构：
  
  上海交通大学机械与动力工程学院
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0253-4339.2023.02.104
  CLC：
- Published：2023
- 稿件说明：
移动端阅览
Hu Jinting, Gu Bo, Zeng Weijie, et al. Modeling of Lubricant Retention in Suction Lines with R32/PVE Oil Mixture Based on Different Flow Patterns[J]. Journal of refrigeration, 2023, 44(2).
DOI：

Hu Jinting, Gu Bo, Zeng Weijie, et al. Modeling of Lubricant Retention in Suction Lines with R32/PVE Oil Mixture Based on Different Flow Patterns[J]. Journal of refrigeration, 2023, 44(2). DOI： 10.3969/j.issn.0253-4339.2023.02.104.

摘要

本文实验研究了R32/PVE 68混合物在过热度为12 ℃、饱和温度为7.5 ℃、名义油质量分数为0%?5%、制冷剂质流密度为90?230 kg/(m2?s)下的滞油情况，采用拆除称重法测量4种不同倾角（水平、45°、60°、竖直）吸气管内的滞油量，使用高速相机获取混合物流型。结果表明：当质流密度为90?120 kg/(m2?s)、流型为分层波纹流时，滞油量随质流密度的增加而增大，其余工况下滞油量均随质流密度的增加而减小；当含油率为1%时，质流密度在达到160 kg/(m2?s)后，流型发生转变，由波纹层状流转变为波纹环状流，并逐渐成为完全发展的环状流。采用基于流型分析的偏心圆模型预测压缩机吸气管滞油量，结果表明87.83%的实验数据误差在?20%，平均绝对误差为9.35%。为进一步验证该模型适用范围，建立了关于滞油量的数据库，共291个数据点，平均绝对误差12.90%，最大绝对误差为65.77%，证明该模型可以较好的预测吸气管内滞油量。

Abstract

This paper presents an experimental study and a model for the oil retention and flow pattern of an R32/PVE 68 mixture in compressor suction lines. The test conditions involved a saturation temperature of 7.5 ℃ and a superheat degree of 12 ℃. The refrigerant mass flux and nominal oil mass fraction (OMFno) were varied within the ranges of 90–230 kg/(m2·s) and 0%–5%

respectively. The test samples were two smooth copper pipes with horizontal and vertical flow orientations with an inner diameter of 10.7 mm. A high-speed camera was used to record the flow pattern. The results showed that when the mass flux was from 90 to 120 kg/(m2·s) and the flow pattern was a stratified wavy flow

the amount of oil retention decreased with an increase in mass flux; in other cases

the amount of oil retention increased with an increase in mass flux. When the oil mass fraction was 1% and the mass flux reached 160 kg/(m2·s)

the flow pattern changed to a wavy annular flow and gradually developed into an annular flow. The double-circle model based on the flow pattern was used to predict the oil retention in the suction line. The results showed a mean absolute deviation of 9.35%

and 87.83% of the data were within ±20% error. To further verify the applicability of the model

291 data points were collected from five open literature

achieving a mean absolute deviation of 12.90% and a maximum absolute deviation of 65.77%

which proves that the model can accurately predict the oil retention in the suction line.

关键词

Keywords

references

Views

952

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Calculation Models of Properties of POE/R32and PVE/R32 and the Properties Analysis

Performance Analysis of Absorption Refrigeration Cycles Using DME or R600a and Squalane as Working Pair

Study on Oil Retention Impact Factor and Pressure Drop Characteristics of R32/PVE Mixture in Compressor Suction Line

Experimental Study on Flow Boiling Heat Transfer and Pressure Drop Characteristics of R245fa in a Dimpled Flat Tube

Research Progress in Composite-enhanced Flow Boiling Heat Transfer for Refrigerants

Related Author

Shi Hongyan

Wu Jianhua

Jia Xiucan

Luo Yong

Wang Xiaopo

Du Zhongxing

Feng Ye

Ding Puxian

Related Institution

School of Energy and power Engineering，Xi’an Jiaotong University

Key Laboratory of Thermo-Fluid Science and Engineering, Ministry of Education, School of Energy and Power Engineering, Xi’an Jiaotong University

College of Modern Logistics, Guangzhou Panyu Polytechnic

School of Energy and Power Engineering, Huazhong University of Science and Technology

College of Ocean and Civil Engineering, Dalian Ocean University

Address：10/F, Yindu Mansion, 67 Fucheng Road, Haidian Dist, Beijing, China Postal code：100142
Tel：010-68711412 Email：editor@car.org.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09064830号-19 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰