Optimization of Temperature Response Characteristics for Thermoelectric Cooling Microfluidics

Zhu Jiang; Sun Dongfang; Gao Cai; Tang Jingchun; Zhang Xiuping; Yang Lei; Liu Xiangnong

doi:10.3969/j.issn.0253-4339.2022.05.033

您当前的位置：

首页 >

文章列表页 >

Optimization of Temperature Response Characteristics for Thermoelectric Cooling Microfluidics

更新时间：2024-07-18

- Optimization of Temperature Response Characteristics for Thermoelectric Cooling Microfluidics
- Journal of Refrigeration Vol. 43, Issue 5, (2022)
- 作者机构：
  
  1. 合肥工业大学汽车与交通工程学院
  2. 压缩机技术国家重点实验室（压缩机技术安徽省实验室
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0253-4339.2022.05.033
  CLC：
- Published：2022
- 稿件说明：
移动端阅览
Zhu Jiang, Sun Dongfang, Gao Cai, et al. Optimization of Temperature Response Characteristics for Thermoelectric Cooling Microfluidics[J]. Journal of refrigeration, 2022, 43(5).
DOI：

Zhu Jiang, Sun Dongfang, Gao Cai, et al. Optimization of Temperature Response Characteristics for Thermoelectric Cooling Microfluidics[J]. Journal of refrigeration, 2022, 43(5). DOI： 10.3969/j.issn.0253-4339.2022.05.033.

摘要

精确的温度调控是微流体技术在生化分析和医学诊断等方面发展应用的重要保障。为实现微流体芯片目标区域的温度控制，本文设计了基于异型结构热电制冷器的微流体芯片温度控制系统，通过数值模拟和实验测试分析了该温控系统的传热特性及及温度响应特性。研究结果表明：采用的热电制冷器可将微流体芯片样品池的温度降至-24 ℃，但样品池的降温速率远小于热电制冷器的冷端降温速率，存在温度响应迟滞问题。为此，进一步提出了带有聚冷结构的系统优化，结果表明：聚冷结构的引入虽然会带来少量的冷量损失，但可以显著提升该温控系统的温度响应速率，有效减少响应时间。对于T型聚冷结构，当下底直径为14 mm和10 mm时，可分别将温度响应时间减少30%和40.7%。

Abstract

Precise temperature control is needed for developing and applying microfluidic technology in biochemical analysis and medical diagnosis. A temperature control system based on a thermoelectric cooler with a specially shaped structure was designed to realize the temperature control of the target area of microfluidic chips. The heat transfer and temperature response characteristics of the temperature control system were analyzed based on numerical simulation and experimental tests. The results showed that the thermoelectric cooler reduced the temperature of the sample cell of the microfluidic chip to -24 ℃. However

the pull-downrate of the sample cell was much lower than that of the thermoelectric cooler

which exhibited temperature response hysteresis. To address this challenge

a T-shaped concentrated cooling structure was proposed. The results showed that the concentrated cooling structure substantially improved the response rate of the temperature control system and effectively reduced the response time

at the cost of consuminga small amount of cooling. For the concentrated cooling structure with a lower diameter of 14 mm and 10 mm

the temperature response time was reduced by 30% and 40.7%

respectively.

关键词

Keywords

references

Views

1178

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Numerical Simulation and Experimental Study of a Thermoelectric Refrigeration Thermal Management System Based on Flat Heat Pipes

Thermoelectric Cooling Application and Optimization: A Review

Numerical Simulation and Experimental Study of Fuzzy-PID Control Method for Liquid Nitrogen Direct Evaporation Refrigeration System

Examining the Linear Cooling Characteristics of Microfluid Based on Thermoelectric Refrigeration

Related Author

张梦飞

韩雪

朱俊叶

唐景春

周培

程文龙

高才

孙东方

Related Institution

合肥工业大学汽车与交通工程学院

中国科学技术大学工程科学学院

南京航空航天大学能源与动力学院

School of Energy and Power Engineering, Nanjing University of Science and Technology

Institute of Refrigeration and Cryogenics, Shanghai Jiao Tong University

Address：10/F, Yindu Mansion, 67 Fucheng Road, Haidian Dist, Beijing, China Postal code：100142
Tel：010-68711412 Email：editor@car.org.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09064830号-19 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰