Experimental Analysis of Periodic Heat Release of Shaped-stabilized Phase-change Thermal Storage Unit

Li Wei; Liu Xiangnong; Yang Lei; Yang Ye; Niu Yulong; Wu Tao

doi:10.3969/j.issn.0253-4339.2021.02.137

您当前的位置：

首页 >

文章列表页 >

Experimental Analysis of Periodic Heat Release of Shaped-stabilized Phase-change Thermal Storage Unit

更新时间：2024-07-18

- Experimental Analysis of Periodic Heat Release of Shaped-stabilized Phase-change Thermal Storage Unit
- Journal of Refrigeration Vol. 42, Issue 2, (2021)
- 作者机构：
  
  1. 合肥工业大学汽车与交通工程学院
  2. 中国电子科技集团公司第十六研究所
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0253-4339.2021.02.137
  CLC：
- Published：2021
- 稿件说明：
移动端阅览
Li Wei, Liu Xiangnong, Yang Lei, et al. Experimental Analysis of Periodic Heat Release of Shaped-stabilized Phase-change Thermal Storage Unit[J]. Journal of Refrigeration, 2021, 42(2).
DOI：

Li Wei, Liu Xiangnong, Yang Lei, et al. Experimental Analysis of Periodic Heat Release of Shaped-stabilized Phase-change Thermal Storage Unit[J]. Journal of Refrigeration, 2021, 42(2). DOI： 10.3969/j.issn.0253-4339.2021.02.137.

摘要

针对相变蓄热材料实际应用中的周期性释热情况，本文采用响应面法设计实验方案，对一种基于圆环形赤藻糖醇/膨胀石墨复合相变材料的间接式蓄热器进行周期性释热实验。利用蓄热材料的释热量、释热动力、有效能利用率对蓄热单元的释热性能进行分析。结果表明：当间歇时间为20 min，材料累计释热时间为40 min，总释热功率、斯蒂芬数、?效率均随着运行时间的增加存在极值，其中?效率极值出现时间相对于总释热功率和斯蒂芬数要滞后22%，综合考量3个评价指标得出运行时间7.7 min为最佳结果。

Abstract

For the problem of periodic heat release in the practical application of phase-change thermal storage materials

a response surface method was used to design an experimental program on an indirect heat accumulator

based on a circular erythritol/expanded graphite composite phase-change material. The performance evaluation of the thermal storage unit was carried out through the total heat release

potential heat

and effective energy utilization of the thermal storage material. The results showed that when the intermittent time was 20 min and the cumulative heat release time of the material was 40 min

with the increase in running time

the total heat release

Stephen number

and exergy efficiency had extremum values. In addition

the appearance time of the extremum of the exergy efficiency was 22% lagged behind those of the total heat release and Stephen number. It was concluded that the running time of 7.7 min is the best value that simultaneously satisfies the optimization of the three evaluation indicators.

关键词

Keywords

references

Views

1929

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experimental Study on Performance of Discharging Process of Phase Change Thermal Storage System

Experimental Research on Nanotitanium-erythritol Energy Storage System

Related Author

Zhang Zhiqiang

Chen Hua

Zhou Chu

Zhang Xuelai

Ding Jinhong

Luo Xiaoxue

Xu Weiwen

Related Institution

School of Mechanical Engineering, Tianjin University of Commerce

Institute of Cooling Energy Storage Technology, Shanghai Maritime University

Address：10/F, Yindu Mansion, 67 Fucheng Road, Haidian Dist, Beijing, China Postal code：100142
Tel：010-68711412 Email：editor@car.org.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09064830号-19 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰