Effect of Vacuum on the Start-up Performance of Loop Heat Pipe Enhanced by Pressure Head of Evaporation

Zhang Guodong; Sun Huan; Zhu Kai; Li Xueqiang; Yang Zhen; Wang Yabo

doi:10.3969/j.issn.0253-4339.2020.03.147

您当前的位置：

首页 >

文章列表页 >

Effect of Vacuum on the Start-up Performance of Loop Heat Pipe Enhanced by Pressure Head of Evaporation

更新时间：2024-07-18

- Effect of Vacuum on the Start-up Performance of Loop Heat Pipe Enhanced by Pressure Head of Evaporation
- Journal of Refrigeration Vol. 41, Issue 3, (2020)
- 作者机构：
  
  天津商业大学天津市制冷技术重点实验室
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0253-4339.2020.03.147
  CLC：
- Published：01 January 2020
- 稿件说明：
移动端阅览
Zhang Guodong, Sun Huan, Zhu Kai, et al. Effect of Vacuum on the Start-up Performance of Loop Heat Pipe Enhanced by Pressure Head of Evaporation[J]. Journal of refrigeration, 2020, 41(3).
DOI：

Zhang Guodong, Sun Huan, Zhu Kai, et al. Effect of Vacuum on the Start-up Performance of Loop Heat Pipe Enhanced by Pressure Head of Evaporation[J]. Journal of refrigeration, 2020, 41(3). DOI： 10.3969/j.issn.0253-4339.2020.03.147.

摘要

在环路热管运行中工质蒸发产生的气相压头有着重要作用。为了研究工质相变产生的气相压头的影响，本文设计了一种新型结构，将环路热管蒸发器内的吸液芯与加热底板彻底分离形成蒸发腔，使蒸发器内的传热传质相对分离，维持蒸发现象仅在蒸发腔内发生，以此来提高环路热管的驱动力。本文选用导热系数较低的不锈钢-镍作为吸液芯材料，尽可能的减少蒸发器的“漏热”现象。通过实验研究了不同真空度（95.3~101.1 kPa）时环路热管系统的启动性能。结果表明：此类型的环路热管可以在不同真空度下正常运行，并且真空度越高，环路热管的运行温度越低，启动时间越短，热阻越低。同时将突出气相压头的环路热管与另外三种不同结构的毛细抽力环路热管进行对比，发现突出气相压头的环路热管具有更低的运行热阻（0.14 ℃/W）。

Abstract

The influence of the pressure head of evaporation on the operation of a loop heat pipe (LHP) is important to the performance of LHP. In this paper

the wick was separated from the heating surface;consequently

a steam chamber was formed. Simultaneously

the heat and mass transfer in the evaporator were separated. Consequently

the driving force (especially the pressure head of evaporation) was enhanced. Heat leakage was decreased as much as possible due to the low thermal conductivity of the wick. Experiments were conducted to investigate the effectof different partial vacuums(95.3–101.1 kPa) on the start-up performance for the new LHP. This newdesign was able to operate at different partial vacuums; the operating temperature

start-up time

and thermal resistance decreased with increasedpartial vacuum. Simultaneously

this LHP showed a lower thermal resistance (0.14oC/W) compared with that of LHP driven by capillary forces.

关键词

Keywords

references

Views

1943

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experiment Study and Visualization of the Startup Characteristics of a Loop Heat Pipe Enhanced by the Pressure Head due to Evaporation

Experimental Study on Miniature Loop Heat Pipe with Flat Evaporator

Optimal Design of Heat Pipe Based on the Multi-object Genetic Algorithm

Performance Study on Improved Vacuum Ice Slurry Making Equipment

Experimental Study on Thermal Performance of Pulsating Heat Pipe with Aqueous Ethanol Fluids

Related Author

Li Hailong

Wang Yabo

Li Xueqiang

Dong Beibei

Zhu Kai

盖东兴

杨金国

刘伟

Related Institution

Tianjin Key Laboratory of Refrigeration Technology, Tianjin University of Commerce

华中科技大学能源与动力工程学院

School of Energy and Power Engineering, University of Shanghai for Science and Technology

School of Energy and Power Engineering, University of Shanghai for Science & Technology

North China Electric Power University, State Key Laboratory of Alternate Electrical Power System with Renewable Energy Sources, Beijing Key Laboratory of Multiphase Flow and Heat Transfer

Address：10/F, Yindu Mansion, 67 Fucheng Road, Haidian Dist, Beijing, China Postal code：100142
Tel：010-68711412 Email：editor@car.org.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09064830号-19 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰