Performance Study and Optimization on Alternative Refrigerant R290 in R22 Low Temperature Heat Pump System

Zhang Yun; Liu Cichong; Chen Xiaoning; Li Dawei; Shi Junru; Chen Jiangping

doi:10.3969/j.issn.0253-4339.2019.03.072

您当前的位置：

首页 >

文章列表页 >

Performance Study and Optimization on Alternative Refrigerant R290 in R22 Low Temperature Heat Pump System

更新时间：2024-07-18

- Performance Study and Optimization on Alternative Refrigerant R290 in R22 Low Temperature Heat Pump System
- Journal of Refrigeration Vol. 40, Issue 3, (2019)
- 作者机构：
  
  1. 上海交通大学制冷与低温工程研究所
  2. 上海市高效冷却系统工程技术中心
  3. 浙江盾安人工环境股份有限公司
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0253-4339.2019.03.072
  CLC：
- Published：2019
- 稿件说明：
移动端阅览
Zhang Yun, Liu Cichong, Chen Xiaoning, et al. Performance Study and Optimization on Alternative Refrigerant R290 in R22 Low Temperature Heat Pump System[J]. Journal of refrigeration, 2019, 40(3).
DOI：

Zhang Yun, Liu Cichong, Chen Xiaoning, et al. Performance Study and Optimization on Alternative Refrigerant R290 in R22 Low Temperature Heat Pump System[J]. Journal of refrigeration, 2019, 40(3). DOI： 10.3969/j.issn.0253-4339.2019.03.072.

摘要

本文从实验角度研究了R22低温热泵系统中R290的替代性能，通过对比不同工况下两者的性能差异发现：直接在原系统中将R22抽出灌装R290时，系统换热量与COP均有所衰减，且在低温环境中R290系统的压缩机排气温度和排气压力均高于原R22系统。通过分析系统部件可知，上述现象出现的主要原因是R22系统压缩机排量过大、与R290系统不匹配，因此为同时满足系统的安全性要求以及提高R290在低温热泵系统中的整体性能，考虑在系统中更换与R290更为匹配的排量更小的压缩机。实验结果表明：对R290低温热泵系统压缩机排量进行优化能有效降低系统的排气温度和压力、提高系统整体性能；压缩机优化后的R290低温热泵系统COP较原R22系统提高6.5%，低温环境下排气温度降低36%，至80 ℃以下。

Abstract

This study addresses the experimental performance of the alternative refrigerant R290 in the R22 low-temperature heat pump system. Results show that when R22 was directly replaced by R290 in the original system

both the heat exchange and coefficient of performance (COP) of the system decreased

and the exhaust temperature and pressure of the R290 system were higher than those of the original R22 system at low temperatures. Through the analysis of the system components

reducing the displacement of the compressor of the R290 heat pump system can effectively improve overall performance and reduce the discharge temperature and pressure. After the optimization of the compressor

the R290 system achieved a 6.5% higher COP compared to the original R22 system

and the exhaust temperature was decreased to 80 °C

which is 36% lower than the R22 system.

关键词

Keywords

references

Views

2597

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Cooling and Heating Performance of an R290 Heat Pump System for Electric Cars

Simulation analysis and experimental study on R290 substituting for R134a electric vehicle compressor

Comparison of Tribological Characteristics of Vane-piston Interface between R290 and R410A in Rotary Compressor

Theoretical and Experimental Study on Drying Performance and Prediction Model of Heat Pump Clothes Dryer

Experimental Study on a Hundred-Watt Highly-Efficient Displacer-Type Pulse Tube Cryocooler

Related Author

Huang Guangyan

Zou Huiming

Tang Mingsheng

Tian Changqing

Wu Jiang

Yu Weibin

CHEN Jianhong

TAO Leren

Related Institution

Technical Institute of Physics and Chemistry, CAS

University of Chinese Academy of Sciences

Shanghai Key Laboratory of Multiphase Flow and Heat Transfer in Power Engineering, University of Shanghai for Science and Technology

Zhejiang Zhongguang Electrical Co., Ltd

Institute of Refrigeration and Cryogenics, University of Shanghai for Science and Technology

Address：10/F, Yindu Mansion, 67 Fucheng Road, Haidian Dist, Beijing, China Postal code：100142
Tel：010-68711412 Email：editor@car.org.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09064830号-19 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰