Di Qianqian, Yang Zhaodan, Liu Bin, et al. Study on the Influencing Factors of Cold Storage Incubator with Al2O3-H2O Nanofluids by Orthogonal Method[J]. Journal of refrigeration, 2017, 38(1).
DOI:
Di Qianqian, Yang Zhaodan, Liu Bin, et al. Study on the Influencing Factors of Cold Storage Incubator with Al2O3-H2O Nanofluids by Orthogonal Method[J]. Journal of refrigeration, 2017, 38(1). DOI: 10.3969/j.issn.0253-4339.2017.01.073.
Study on the Influencing Factors of Cold Storage Incubator with Al2O3-H2O Nanofluids by Orthogonal Method
In order to improve the effect of cold storage in box with nano fluid
the low density sponge is used to adsorb nano particles and the thermophysical properties of the coolant is changed. The carrots are used as the experimental object in the experiments by orthogonal method. And the integral value of average temperature of the air in the box is taken as the index to compare the effect of cool storage. The influence of thickness of porous sponge (8 mm
16 mm
20 mm)
mass fraction of nanofluids (0.1%
0.15%
0.2%)
quality of cold storage materials for per kilogram of vegetables (0.429 kg
0.5 kg
0.571 kg)
and pre-cooling temperature of vegetables (-1 ℃
4 ℃
12 ℃) on the refrigeration effect in the incubator were explored. The results of the study are as follows: (1) the importance sequences of factors are pre-cooling temperature of vegetables
mass fraction of nanofluids
the quality of cold storage materials for per kilogram of vegetables
and the thickness of porous sponge; (2) with the increasing of the thickness of porous sponge
the mass fraction of nanofluids
and the quality of cold storage materials for per kilogram of vegetable
the effect of cooling storage will be better. The optimal pre-cooling temperature is 4 ℃ out of 12 ℃
4 ℃
- 1 ℃; (3) the optimal combination of all the factors for the effect of cool storage is as following: the thickness of porous sponge of 20 mm
the mass fraction of 0.2%
the quality of cold storage materials for per kilogram of vegetable of 0.571 kg
and vegetables pre-cooling temperature of 4 ℃. But the porous sponge of 16 mm instead of 20 mm
and the mass fraction of nanofluids of 0.15% instead of 0.2% are suggested for economical reason. This experiment method and results provide a theoretical basis for further experiments and analysis.