Numerical Simulation and Experimental Verification of Temperature Uniformity in a Novel Multi-temperature Thermostat

Zhao Xiuhong; Liu Baolin

doi:10.3969/j.issn.0253-4339.2015.02.027

您当前的位置：

首页 >

文章列表页 >

Numerical Simulation and Experimental Verification of Temperature Uniformity in a Novel Multi-temperature Thermostat

更新时间：2024-07-18

- Numerical Simulation and Experimental Verification of Temperature Uniformity in a Novel Multi-temperature Thermostat
- Journal of Refrigeration Vol. 36, Issue 2, (2015)
- 作者机构：
  
  上海理工大学生物系统热科学研究所
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0253-4339.2015.02.027
  CLC：
- Published：2015
- 稿件说明：
移动端阅览
Zhao Xiuhong, Liu Baolin. Numerical Simulation and Experimental Verification of Temperature Uniformity in a Novel Multi-temperature Thermostat[J]. Journal of refrigeration, 2015, 36(2).
DOI：

Zhao Xiuhong, Liu Baolin. Numerical Simulation and Experimental Verification of Temperature Uniformity in a Novel Multi-temperature Thermostat[J]. Journal of refrigeration, 2015, 36(2). DOI： 10.3969/j.issn.0253-4339.2015.02.027.

摘要

本文针对自行设计的一种新型的具有三个箱体的多温区恒温箱进行其均温性的研究。以多温区恒温箱的一个箱体为研究对象，建立了三维稳态数值模型，模拟了加热器情况不同时该箱体内的温度分布。结果表明

采用方形薄片加热器并布置于风机下方时，该箱体内的温度场最均匀。恒温箱三个箱体的加热器均采用上述情况后，对其设定了工况1（各箱体的设定温度分别为﹣15 ℃，﹣10 ℃，﹣5 ℃)和工况2（各箱体的设定温度分别为﹣20 ℃，﹣15 ℃，﹣10 ℃)进行实验。结果显示，工况1（即模拟工况）下的模拟值与实测值较吻合，最大误差为3.1%；两种工况下各箱体的温度均匀度最大为0.54 ℃。结果表明，在不同的测试工况下该多温区恒温箱各箱体内的温度分布都能维持均匀。

Abstract

In this paper

the temperature uniformity of a self-designed novel multi-temperature thermostat with three chambers was studied. A steady-state three-dimensional numerical model based on one chamber ofthe thermostat was built to simulate its temperature distribution under different heater conditions. The results showed that the most uniform temperature distribution was obtained under the condition that the square-shaped heater was used and installed under the fan. Then with all chambers under such heater condition

the thermostat was tested under mode 1 (the temperatures for the chambers were set to ﹣15 ℃

﹣10 ℃ and ﹣5 ℃

respectively) and mode 2 (the temperatures for the chambers were set to ﹣20 ℃

﹣15 ℃ and ﹣10 ℃

respectively). The simulated values were in good agreement with the measured values with the maximum error of 3.1% under mode 1 (the simulated mode)

and the maximum temperature uniformity in the chambers was 0.54 ℃under the two tested modes. The obtained results showed that the temperature distribution within all chambers of this novel multi-temperature thermostat could keep uniform under different tested modes.

关键词

Keywords

references

Views

2390

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experimental and Simulation Study on Thermal Performance of Small-volume Vaccine Cold Storage at 2–8 ℃

Numerical and Experimental Study of the Temperature Distribution Characteristics of a Cryogenic Non-thermal Equilibrium Cylinder

CFD Simulation and Experimental Study on Temperature Field Uniformity in Environmental Test Chamber

Influence of angle adjustment of theoutlet blade on thermal comfort

Related Author

Zhang Haoyue

Zhang Zhongbin

Go Chenghua

Wang Wei

Du Yicen

Cheng Ruijie

Wu Shize

Cai Aifeng

Related Institution

Jiangsu Provincial Center for Disease Control and Prevention

School of Energy and Mechanical Engineering, Nanjing Normal University

Institute of Refrigeration and Cryogenics, Shanghai Jiao Tong University

Gongqin Environment Technology Co.,Ltd.

School of Energy and Power Engineering, Nanjing Institute of Technology

Address：10/F, Yindu Mansion, 67 Fucheng Road, Haidian Dist, Beijing, China Postal code：100142
Tel：010-68711412 Email：editor@car.org.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09064830号-19 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰