Optimization Study of Bell Mouth on Multi-blade Centrifugal Fan used in Floor Standing Air-conditioner

doi:10.3969/j.issn.0253-4339.2012.03.058

您当前的位置：

首页 >

文章列表页 >

Optimization Study of Bell Mouth on Multi-blade Centrifugal Fan used in Floor Standing Air-conditioner

更新时间：2024-07-18

- Optimization Study of Bell Mouth on Multi-blade Centrifugal Fan used in Floor Standing Air-conditioner
- Journal of Refrigeration Vol. 33, Issue 3, (2012)
- 作者机构：
  
  1. 华中科技大学
  2. 华中科技大学，广东志高空调有限公司
  3. 广东志高空调有限公司
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0253-4339.2012.03.058
  CLC：
- Published：2012
- 稿件说明：
移动端阅览
Optimization Study of Bell Mouth on Multi-blade Centrifugal Fan used in Floor Standing Air-conditioner[J]. Journal of refrigeration, 2012, 33(3).
DOI：

Optimization Study of Bell Mouth on Multi-blade Centrifugal Fan used in Floor Standing Air-conditioner[J]. Journal of refrigeration, 2012, 33(3). DOI： 10.3969/j.issn.0253-4339.2012.03.058.

摘要

通过数值模拟对空调柜机风道的三维流场进行计算，并对三种多翼离心风机的集流器结构进行对比研究。数值模拟结果显示：相比于原机型自带的收敛型集流器，轴向高度矮于原?机型的收敛型集流器和进口倾斜角度相比原?机型减小的新型线收敛型集流器都可以提高叶轮对气流的利用率，蜗壳出口侧的集流器背部的漩涡减小，风量分别增加6.8%和4.2%。通过实验对数值模拟结果进行了验证，实验结果显示两种方案对整机循?环风量都有所提高，风量分别增加4.7%和3%，噪音值不变。

Abstract

Numerical study of three-dimensional flow field was carried out for the duct system of the floor standing air-conditioner. Comparative study on three types of structure of bell mouth used in the multi-blade centrifugal fan was implemented. Calculation results show that

both the first type of bell mouths with the inward inlet whose axial height is larger than the existing type and the second type of bell mouth with new mold line inward inlet and smaller slope angle than the existing type can improve airflow utilization ratio and reduce the vortex in the back of volute exit compared to the existing type

and the air volume is increased by 6.8% and 4.2% respectively. The experiment was carried out to validate the result of simulation and the experimental results show that the air volume can increase by 4.7% and 3% respectively while the level of noise is invariant.

关键词

Keywords

references

Views

2019

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

The Analysis of Heat Transfer Coefficient in Freezing Process of Cryotop

Research Development of Numerical Simulation for Display Cabinets and Air Curtains

Heat Storage and Discharge Characteristics of Flat Filling Phase Change Thermal Energy Storage Tank

Thermal Resistance Analysis and Numerical Optimization of Mechanical Expanded Tube-to-Fin Joints

Design of High Efficiency Cooler for IGBT Module in CRH2

Related Author

Wang Haisong

Zhou Xinli

Li Weijie

Liu Hanyi

Zhang Liang

Yang Yang

Cao Jiayuan

Li Sisi

Related Institution

Institute of Biothermal Technology, University of Shanghai for Science and Technology

School of Energy and Power Engineering, University of Shanghai for Science and Technology

Institute of Refrigeration and Cryogenics, University of Shanghai for Science and Technology

National Virtual Simulation Experimental Teaching Center for Building EnergySchool of Environmental and Energy Engineering

Beijing University of Civil Engineering and Architecture

Address：10/F, Yindu Mansion, 67 Fucheng Road, Haidian Dist, Beijing, China Postal code：100142
Tel：010-68711412 Email：editor@car.org.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09064830号-19 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰