Experimental Study on Heat Transfer Performance and Pressure Drop of Microchannel Liquid Separation Condenser

QIAN Puchi; WANG Dechang; SONG Qinglu; ZHOU Sai; YAN Zhijian

您当前的位置：

首页 >

文章列表页 >

Experimental Study on Heat Transfer Performance and Pressure Drop of Microchannel Liquid Separation Condenser

更新时间：2025-01-17

- Experimental Study on Heat Transfer Performance and Pressure Drop of Microchannel Liquid Separation Condenser
- Moren Journal (2025)
- 作者机构：
  
  1.青岛大学机电工程学院,山东省青岛市266071
  2.海信冰箱有限公司,山东省青岛市266071
- 作者简介：
- 基金信息：
  
  the National Natural Science Foundation of China(52106016)
- DOI：
  CLC： TB657.5;TK124
- Received：20 September 2024，
  
  Revised：03 December 2024，
  
  Accepted：2024-12-06
- 稿件说明：
移动端阅览
QIAN PUCHI, WANG DECHANG, SONG QINGLU, et al. Experimental Study on Heat Transfer Performance and Pressure Drop of Microchannel Liquid Separation Condenser. [J/OL]. Moren journal, 2025.
DOI：

QIAN PUCHI, WANG DECHANG, SONG QINGLU, et al. Experimental Study on Heat Transfer Performance and Pressure Drop of Microchannel Liquid Separation Condenser. [J/OL]. Moren journal, 2025. DOI：

摘要

制冷剂质量流量1g/s以下的低质量流量下分液孔的大小和位置对分液冷凝器的性能有重要影响。对R600a在5种不同微通道分液冷凝器内的换热性能和压降进行了实验研究，对不同制冷剂质量流量、入口空气温度和速度、冷凝压力下5种分液冷凝器的换热性能和压降特性进行分析。根据实验结果，第二隔板开孔分液冷凝器换热性能优于第三隔板开孔分液冷凝器。制冷剂质量流量越大，分液冷凝器制冷剂侧压降减小越明显。制冷剂质量流量为0.6 g/s时，第二隔板开孔分液冷凝器制冷剂侧压降较未分液冷凝器降低21.28%；为0.4 g/s时，第二隔板开孔分液冷凝器制冷剂侧压降较未分液冷凝器降低17.29%。利用综合评价因子

比较了不同开孔直径分液冷凝器的性能，分液孔径1.2 mm的分液冷凝器平均

值为1.58，在所有分液冷凝器中最高，综合性能最好。

Abstract

The size and location of theseparating holes at low mass flow rates below 1 g/s have a significant impacton the performance of the liquid separation condenser. The heat transferperformance and pressure drop of R600a in five different microchannel liquidseparation condensers were experimentally studied

and the heat

transferperformance and pressure drop characteristics of five liquid separationcondensers under different refrigerant mass flow

inlet air temperature andvelocity

and condensing pressure were analyzed. According to the experimental results

the heat exchangeperformance of the second partition open-hole separating condenser is higherthan that of the third separator open-hole separating condenser. As the mass flow rate of therefrigerant increases

the refrigerant side pressure drop of the liquidseparation condenser decreases more significantly. When the refrigerant massflow rate is 0.6 g/s

the refrigerant side pressure drop of the secondseparator liquid separation condenser is 21.28% lower than that of the parallelflow condenser

and when the refrigerant mass flow rate is 0.4 g/s

the refrigerantside pressure drop of the second separator liquid separation condenser is17.29% lower than that of the parallel flow condenser. The performance of the liquidseparation condenser with different open-hole diameters was compared by usingthe comprehensive evaluation factor

the average

value of the liquid separation condenser with a separating hole size of 1.2 mm is 1.58

which is the highest among all liquid separation condensers and has the bestcomprehensive performance.

关键词

分液冷凝器分液孔径分液隔板位置换热性能压降

Keywords

liquid separation condenserseparating hole sizeposition of the separatorheat transfer performancepressure drop

references

彭晓峰, 吴迪, 张扬. 高性能冷凝器技术原理与实践. 化工进展[J]. 2007, (01): 97-104.

PENG Xiaofeng, WU Di, ZHANG Yang. Applications and principle of high performance condensers. Chemical Industry and Engineering Progress[J]. 2007, (01): 97-104.

LI Jian, LIU Qiang, DUAN Yuanyuan, et al. Performance analysis of organic Rankine cycles using R600/R601a mixtures with liquid-separated condensation[J]. Applied Energy, 2017, 190: 376-389.

CHEN Jianyong, YANG Nuo, Li Junjie, et al. Evaluations of heat pump water heater with liquid-separation condensation from perspectives of performance enhancement and heat exchange area reduction[J]. International Journal of Refrigeration, 2024, 161: 21-30.

LI Jun, HRNJAK P. Separation in condensers as a way to improve efficiency[J]. International Journal of Refrigeration, 2017, 79: 1-9.

LI Jun, HRNJAK P. Visualization and quantification of separation of liquid-vapor two-phase flow in a vertical header at low inlet quality[J]. International Journal of Refrigeration, 2018, 85: 144-156.

LI Wanyong, TU Jian, LIU Yusheng, et al. Design and experimental validation of a new condenser of an automotive air conditioning unit to address non-uniform air velocity distributions[J]. International Journal of Refrigeration, 2021, 131: 834-846.

刘策, 贾力, 张旋. R134a在风冷分液式冷凝换热器中的换热性能研究[J]. 工程热物理学报, 2019, 40(07): 1620-1626.

LIU Ce, JIA Li, ZHANG Xuan. Study on Heat Transfer Performance of R134a in Air-Cooling Liquid-Vapor Separation Condenser[J]. Journal of Engineering Thermophysics, 2019, 40(07): 1620-1626.

孙鼎皓, 贾力, 党超. 风冷式翅片管分液冷凝器的实验研究[J]. 工程热物理学报, 2023, 44(09): 2572-2577.

SUN Dinghao, JIA Li, DANG Chao. Experimental Study on Air-cooled Finned-tube Condenser with Liquid-vapor Separators[J]. Journal of Engineering Thermophysics, 2023, 44(09): 2572-2577.

LIU Ce, JIA Li, ZHANG Xuan, et al. Analysis of the heat transfer characteristics of the liquid-vapor separation condenser based on a condensate growth model in horizontal tube[J]. Applied Thermal Engineering, 2019, 163: 114307.

CHEN Ying, HUA Nan, DENG Lisheng. Performances of a split-type air conditioner employing a condenser with liquid–vapor separation baffles[J]. International journal of refrigeration, 2012, 35(2): 278-289.

CHEN Xueqing, CHEN Ying, DENG Lisheng, et al. Experimental verification of a condenser with liquid–vapor separation in an air conditioning system[J]. Applied Thermal Engineering, 2013, 51(1-2): 48-54.

ZHONG Tianming, CHEN Ying, HUA Nan, et al. In-tube performance evaluation of an air-cooled condenser with liquid–vapor separator[J]. Applied energy, 2014, 136: 968-978.

ZHONG Tianming, CHEN Ying, ZHENG Wenxiong, et al. Experimental investigation on microchannel condensers with and without liquid–vapor separation headers[J]. Applied thermal engineering, 2014, 73(2): 1510-1518.

ZHONG Tianming, DING Lixing, CHEN Shu, et al. Effect of a double-row liquid–vapor separation condenser on an air-conditioning unit performance[J]. Applied Thermal Engineering, 2018, 142: 476-482.

ZHONG Tianming, YANG Junrong, DING Lixing, et al. Heat transfer enhancement of actively-adjusting liquid–vapor in a double-row microchannel condenser[J]. Case Studies in Thermal Engineering, 2023, 47: 103110.

HUANG Kunteng, LI Junjie, CHEN Jianyong, et al. Explorations of multi‐pass‐orifice header in the liquid‐separation condenser by using CFD simulation[J]. International Journal of Heat and Mass Transfer, 2023, 200: 123482.

黄锟腾, 陈健勇, 陈颖, 等. 联箱-小孔型气液分离器的CFD数值模拟[J]. 制冷学报, 2022, 43(01): 158-166.

HUANG Kunteng, CHEN Jianyong, CHEN Ying, et al. Simulation of Vapor-liquid Separation in Header-baffle with Hole using Computational Fluid Dynamics [J]. Journal of Refrigeration, 2022, 43(01): 158-166.

HUANG Kunteng, CHEN Jianyong, CHEN Ying, et al. Simulation of vapor-liquid separation in the orifice-baffle header under various operating conditions [J]. Applied Sciences-Basel, 2022, 12(16): 7971.

CAO Xue, WANG Xiaohe, SONG Qinglu, et al. Experimental investigation on the heat transfer and pressure drop characteristics of R600a in a minichannel condenser with different inclined angles[J]. Applied Thermal Engineering, 2021, 196: 117227.

王栋, 陶银双, 鲁月红, 等. 超临界CO2在螺旋槽管式换热器中的冷却换热[J]. 低温与超导, 2024, 52(01): 58-64.

WANG Dong, TAO Yinshuang, LU Yuehong, et al. Cooling and Heat Transfer of Supercritical CO2 in Spiral Groove Tube Heat Exchanger [J]. Low Temperature and Superconductivity, 2024, 52(01): 58-64.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on the Wet Performance and Long-term Characteristics of Microchannel Heat Exchanger with Surface Coating

Experimental Study on Air-source Heat Pump Water Heater with Vapor-liquid Adjustment Evaporator

Research Status of Microchannel Heat Dissipation Technologybased on Porous Structure

Related Author

Liu Luming

Shi Junye

Wang Ying

Ge Fanggen

Wang Feng

Wei Qingqi

Chen Jiangping

Wen Xuecheng

Related Institution

School of Mechanical Engineering, Shanghai Jiao Tong University

Zhejiang University Dunan Artificial Environment Co.,Ltd.

Tianjin Sanden Auto Air-conditioning Co.,Ltd.

School of Material and Energy, Guangdong University of Technology

Guangdong Provincial Key Laboratory of Functional Soft Condensed Matter

Address：10/F, Yindu Mansion, 67 Fucheng Road, Haidian Dist, Beijing, China Postal code：100142
Tel：010-68711412 Email：editor@car.org.cn
Technical support is provided by Beijing Founder electronics co., LTD 京ICP备09064830号-19 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰